jay_7301
Level 1
Level 1
Member since ‎12-15-2014
‎03-27-2024

User Statistics

  • 71 Posts
  • 0 Solutions
  • 1 Helpful votes Given
  • 17 Helpful votes Received
Recent Badges
10 Helpful Vote
1 Helpful Vote
20 Replies
10 Replies
5 Replies

User Activity

Hi Team,Please can confirm what the below config is try to achieve?Is it doing a PAT to the outside interface then allowing 10.0.255.0 coming from the outside interface to access anything? access-list outside extended permit ip 10.0.255.0 255.255.255...
Hi All,Bit of an odd issue. We see host links bouncing on the fex. We have replaced the fibre/SFP and the sever but still having the same issues so now suspecting an issue with the FEX. Has anyone seen this before? no errors on the host ports -  i di...
Hi All,If you peer between route reflectors clusters and have them setup as back-to-back clients does this disable the cluster-id loop prevention checks?  Just i see routes being sent back to originator RR and that RR accepting them. I thought the or...
Hi All,we have 2 networkseach network runs typical MPLS/IBGP and they have their own set of route reflectors (2 on each network)We want to start exchanging routes between the networks and are hoping to achieve this by peering between the route reflec...
Hi All,I have enabled UDLD on some LAG members that run over fibre, see config below.int eth1/1udld port aggressiveudld fast-hello 300errdisable recovery cause udlderrdisable recovery interval 30with the hello's set at 300ms i was hoping to get a tim...
Community Statistics
Member Since ‎12-15-2014 02:40 PM
Date Last Visited ‎03-27-2024 12:16 AM
Posts 71
Total Helpful Votes Received 17
Helpful Votes From
Helpful Votes Given To