Hi,Though ithe problem is not very much clear from your post, I am replying what I understood.You have to configure NAT for that,either static or PAT.In ASA there is a default NAT-CONTROL.This means every ip wats to pass through pix/ASA , needs a nat...
Hi Michael,Your configuration is perfectly ok.The static statement overlaps the PAT statement.So your servers are going through static NAT.You can also verify this by issueing these commands:sh xlatesh connectionssh local hoststhease will show your l...
First you configure failover in primary firewall(do not power on the sec.)you have to put this commands:interface Ethernet0/3 description LAN/STATE Failover Interface speed 100 duplex fullfailoverfailover lan unit primaryfailover lan interface FAILOV...