About tony000031

tony000031 · 02-06-2015

Good Morning All, I am getting these two errors and I am trying to figure what is the issue. Seeing if someone has ran into this issue.

tony000031 · 01-13-2015

I need your help. I have been having issues with CUCM 8.6.2. When I calls out it rings until the person answers, then it give me a busy signal. When someone calls from the outside, I pickup and nothing happens. At the same time they will get a bus...

tony000031 · 02-22-2015

I apologize for getting back to you so late. I reverted back to the original configuration. Subscriber CSS wasn't configured.Then we made changes to the Region Relationship under Region. I hope that helps.

tony000031 · 02-12-2015

I made the changes you requested, but it didn't resolve the situation. Our Region configuration was set to the default settings. We had to modify the Region relationship to the other Regions. We had to select a Region and set the Max Audio Bit Rate ...

tony000031 · 02-09-2015

Our Region setting were set to default. We need to assign a Region Relationship. I really appreciate your help

tony000031 · 02-09-2015

I have attached the new RTMT after setting the subscriber to none.

tony000031 · 02-08-2015

I left some info off earlier: I notice that under Device ---> Phone ---> Phone Owner.The Device Information CSS and Protocol Specific Subscriber CSS are the same.Device --> Phone --> Subscriber CSS : CM_SSDevice --> TRUNK --> Subscriber CSS: NoneUs...

Member Since	‎12-16-2014 11:24 AM
Date Last Visited	‎08-18-2017 03:50 AM
Posts	20
Total Helpful Votes Received	10

User Statistics

User Activity

401 Unauthorized & 489 Bad Event - 'Malformed/Unsupported Event'

Help needed with Session Description Protocol (SDP) on a Cisco CUCM 8.6.2

I apologize for getting back

I made the changes you

Our Region setting were set

I have attached the new RTMT

I will have to test tomorrow.