About jtgenterprise

jtgenterprise · 06-12-2019

Hi everyone, I am in the process of upgrading a 6509 switch from WS-SUP720-3B to VS-SUP2T-10G. When I installed the 2 line cards, one of them came with the following error: System Bootstrap, Version 12.2(50r)SYS3, RELEASE SOFTWARE (fc1)Technical Supp...

jtgenterprise · 05-20-2019

Hello, I have a requirement to perform a supervisor upgrade for a client. The setup is as following: 2x 6509 switches with 2 active-standby SUP 720-3B supervisors.My client initally stated that the switches were acting as a primary/secondary HSRP pai...

jtgenterprise · 05-20-2019

Wow, This was the most detailed explanation I got regarding a sup upgrade! Thanks. And by the way, I forgot to post the daughtercard output of the switch. You were right, we do need to install new daughtercards. Mod Sub-Module Model Serial Hw Status-...

jtgenterprise · 05-20-2019

Hello,The switches are only running HSRP between them and No VSS.What I was asking is whether I could perform a line card upgrade without powering the entire switch off. I cannot seem to find any documentation whether this is possible or not. Each sw...

Member Since	‎07-22-2018 03:45 AM
Date Last Visited	‎06-19-2019 12:35 AM
Posts	4

User Statistics

User Activity

VS-SUP2T-10G crashes at boot - stucks at rommon.

Seamless upgrade of 6500 from SUP 720-3B to Sup VS-S2T-10G

Re: Seamless upgrade of 6500 from SUP 720-3B to Sup VS-S2T-10G

Re: Seamless upgrade of 6500 from SUP 720-3B to Sup VS-S2T-10G