About michael_todd

michael_todd · 02-10-2009

Is there any way to change the line text label of the "Hunt Group Logout" lines that are added automatically when a line is added to a hunt group? Also, is there any way to change the message that is displayed on the phone when logging into and out o...

michael_todd · 04-20-2009

Again, did you check the device pool and UCM group settings of the GK trunk against the IP that the gatekeeper is using to register? If this is wrong the trunk will still register but the calls will fail.

michael_todd · 04-17-2009

Please read the UCM SRND section on media resources (http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/srnd/6x/media.html). This explains things very well. Basically transcoding is only needed if one of the two devices can't speak the codec that is ...

michael_todd · 04-17-2009

I don't understand your question at all. Technically you could have a single partition (or no partitions) for an entire system and it would "work".

michael_todd · 04-17-2009

This MessageID is for StationCallInfoV2Message. This replaces CallInfoMessage, but I'm not sure in which UCM version this happened. Which UCM version are you using?

michael_todd · 04-17-2009

There is no way to change the default background or to bulk update phone backgrounds.

Member Since	‎06-10-2008 10:26 AM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	21
Total Helpful Votes Received	10

User Statistics

User Activity

CM 6.1 "Hunt Group Logout" line appearance and message

Re: CM7 Gatekeeper Trunk rejects calls

Re: transcoder

Re: Line partitions

Re: Skinny.messageid==0x14a + Calls record

Re: Cisco Call Manager background configuration