About senpai

senpai · 11-12-2019

The ISG is running IOS-XE Version 16.6.4. We have a select number of radius-server attributes configured. However, the ISG is sending the radius attribute 151 in its Accounting-Request packet. In the packet and under the RADIUS Protocol > Attribute V...

senpai · 09-16-2019

Hello,( R1 ) -ibgp-> ( R2 ) -ebgp-> ( R3 )The scenario is that router R1 is announcing routes to R2. Those routes are tagged from R2 inbound using RPL (community is 123:123). Now the R2 has an RPL policy towards R3 which dictates to match any routes ...

senpai · 01-14-2019

I am trying to figure out what is the maximum supported NAT table entries for this EOL Cisco 7301 router. Yes, I know its an old hardware but it still works. The Datasheet shows 16k for 12.2(13)B. I believe this count refers to the BB subscribers sup...

senpai · 01-04-2019

I'm currently seeing the following log messages. only seen after ios-xr upgrade from 5.3.2 to 6.4.2. The session_rekey_count seems to be incrementing over time. SSHD_[65822]: %SECURITY-SSHD-6-INFO_REKEY : Server initiated time rekey for session 1 , s...

senpai · 06-25-2018

I have read through the excellent post on TCP MSS Adjust on ASR9000 by Aleksandar Vidakovic. According to that post, to adjust MSS one must configure the hw-module location 0/0/CPU0 tcp-mss-adjust np 1 value <number> and then apply it on the correspo...

senpai · 09-26-2019

Hi,The idea is routes advertising from R1 "not to be the best routes" in R2. However, we need to advertise those R1 routes towards R3 from R2 using RPL community matching. BGP add-path + multipath might work. I have to lab this and confirm. Thanks fo...

senpai · 01-14-2019

interesting. depending on how the table grows, might as well look into adjusting these timers, if possible. thanks for the input @Joseph W. Doherty

senpai · 01-14-2019

Thanks, @balaji.bandi It is used for a test environment at SP Level :) So expecting quite a fair amount of translation to happen.

senpai · 01-14-2019

Thanks for the tip with max-entries. Since these entries, only would show the capability from the IOS version that's in use rather than the hardware, as you have suggested it would depend on the memory in use. Its currently got 1G of memory.

senpai · 07-01-2018

Hello Anders,I am curious as to what command shows the bundle traffic stats as you have shown in your question.thanks

Member Since	‎07-11-2008 08:40 AM
Date Last Visited	‎11-14-2019 11:16 AM
Posts	11

User Statistics

User Activity

How to remove a specific RADIUS attribute which the ISG sends in the Accounting-Request packet?

How to match certain tagged routes using RPL when they are not the best routes

Cisco 7301 maximum supported NAT table entries

ASR96: SECURITY-SSHD-6-INFO_REKEY Server initiated time rekey for session

How to adjust TCP MSS on ASR9000 Tunnel-Interface?

Re: How to match certain tagged routes using RPL when they are not the best routes

Re: Cisco 7301 maximum supported NAT table entries

Re: Cisco 7301 maximum supported NAT table entries

Re: Cisco 7301 maximum supported NAT table entries

Re: LACP load balancing