hey guys i need some help with VLAN creation on SGE2010 devices.I want to setup the following VLAN's1 - 10.0.5.x123 - 10.0.10.x124 - 10.0.11.x125 - 10.0.12.xI am just trying to figure out exactly how to accomplish this at the moment. I am reading in ...
I am having some issues on my network and i think i have narrowed them down to a single switch.On this switch the following logs can be seen 2147482407 05-May-2012 15:40:54 Informational %AAA-I-CONNECT: New http connection for user admin, sourc...
ok perfect so thats what i have done.So one more question.With each switch now i would need to switch the interface settings to general for the actual fibre links between each switch? Or could i switch all to general for full 802.1Q mode? (according ...
so what i think i will do is keep my switches in L2, and my router will take care of the routing for the VLAN's.Also once i configure all the VLAN's on each switch, do i need a route in between each? Just trying to understand exactly how this is done
Do you mean plug literally into the problem switch and run wireshark? doesnt a switch direct packets to their intended destination and not broadcast it across all ports?Anyways i did run wireshark on the computer i was thinking was the problem but fr...
the issue is that the network almost seizes up when this happends. On 1 specific computer you notice the network icon in windows 7 show that yellow sign and then no network connections work for a few minutes. Once the network sign goes away the netwo...
I think i have the exact same issue... How do you know its going down? By looking at the uptime? for some reason my uptime counter is never high it always resets randomly. Whenever i look in the panel the uptime will read like a few hours when it sho...