We have couple of NAM installed on our network, we want to collect layer-2 Netflow data since some of the NAM mod is installed on access layer switch (all of our switches have Sup 32 witch PFC3B card) which don't have a lot of traffic to affect perfo...

We have a Cisco blade switch 3020, after we set up the Citix servers witch connect to the switch, there are massagees like "%SW_MATM-4-MACFLAP_NOTIF: Host 001c.c4e0.d37e in vlan 202 is flapping between port Gi0/8 and port Gi0/17" constantly showing u...

We just install a NAM-2 on a Cisco 6513, after session into the NAM and configure IP address default gateway, enable HTTP server. NAM can only ping itself, we even can't ping 6513 and gateway. The show IP command shows the right configuration. Accord...

I just intsalled a Cisco 7606 router which has a PA-MC-8TE1+ line card, after I configured card type as T1, I can only see controller instead of serial interface, does someone has this type of problem?