It looks like you are using the smartport macros. You should check the macros to see what is defined...

No, I haven't been able to upgrade yet, but I was wondering if there were any specific configuration...

Is this something you had to configure to work in the new firmware or did you just upgrade to the th...

Thanks, I am not familiar with the concept of frozen IP addresses. Are you suggesting that Cisco has...

Anyone from Cisco care to weigh in on this one? Is this an actual bug with these switches? Is there ...

Did you have any luck with your testing?

Thanks.  Does anyone know if there is a Cisco bug raised on this issue? 

The lease time had been configured for one day so I don't believe that is the issue. But when lookin...

Try changing the maximum entries under routing resources (TCAM utilization) from Use Default to some...

Hello, I am working on an SG300-28P that is doing dhcp for a vlan. The network pool is showing the n...

Before going on site, I called into the SBCS support line with the associated ticket number and aske...

We received the replacement hardware on Monday and went to the customer's site. I managed to get a b...

Hi Steve, I understand the directive to only use the CCA from one point of view. However, certain th...

The PSTN connection is a PRI. With respect to the lights, I will try to get the info, but the system...

We have to do a replacement of a UC560 under an RMA. This is a complete chassis replacement. Does an...