About mvanosdall

mvanosdall · 10-05-2015

Wanting the ability to track when default route goes away, then wait a certain period of time, like 60 seconds, check default once more to make sure it is still gone and if so then proceed with script to remove static routes. Here is what I had so fa...

mvanosdall · 11-01-2005

In what version of the Cisco VPN 3000 client did the support for IPSEC Backup Servers come about?

mvanosdall · 10-23-2001

Wondering if it is possible to use the same interface on a PIX for the VPN Tunnel Peer and the hosts that you are trying to access. We have not got this to work. Wondering if it is possible and if so how and if not why?Thanks

mvanosdall · 10-26-2015

In production my script did not run as we are using AAA authentication. Could you help answer these questions?1) When AAA is accessible you have to enter in a username and password to go into config mode. In this case I would assume I could add the e...

mvanosdall · 10-19-2015

Joe, On your point number 2 I swear I've tested it a couple of times and as long as i bring default route back within the 60 seconds the routes and prefix lists are not removed. I'll test it again tomorrow and let you know. Thanks for all you help.

mvanosdall · 10-19-2015

Based on the following script I have a couple of other questions: 1) When I run this script the device I see this in the logs:Oct 6 19:37:04.461: %HA_EM-3-FMPD_CLI_CONNECT: Unable to establish CLI session: 'Embedded Event Manager' detected the 'fata...

mvanosdall · 10-05-2015

not fully sure I understand yet. When you say set the ED back to none. So what you are saying is under the event manager applet BGP_Remove_STATICS_Timer you would put another action that says what?

mvanosdall · 10-05-2015

Thanks for the input. Here is what I did based on it:event manager applet REMOVE_STATICS_Abort event routing network 0.0.0.0/0 type add action 1.0 cli command "enable" action 2.0 cli command "config t" action 3.0 cli command "event manager applet BGP...

Member Since	‎10-23-2001 10:02 AM
Date Last Visited	‎08-18-2017 03:50 AM
Posts	9

User Statistics

User Activity

EEM Script to trace default route down, wait x amount of time, check to make sure route is still gone and then conitnue running script

IPSEC Backup Server Support on VPN Client

Gateway to Gateway VPN on PIX with single interface

In production my script did

Joe, On your point number 2 I

Based on the following script

not fully sure I understand

Thanks for the input. Here is