awesterink
Level 1
Level 1
Member since ‎01-26-2010
‎08-18-2017

User Statistics

  • 13 Posts
  • 0 Solutions
  • 0 Helpful votes Given
  • 0 Helpful votes Received
Recent Badges
5 Replies

User Activity

I have a RV220W operating in 2.4GHz N-only mode. Channel bandwidth is set to 20MHz, channel to 6 (a site survey shows that channel as completely clear), WPA2/AES. I am connected to a TrendNet wireless bridge. The admin page for that wireless bridge s...
Has anyone managed to access the admin page of the RV220W from an iPad wih the default security certificate? If so, what steps did you go through? Or is this only possible when purchasing a certificate? Thx...
I am running firmware 1.0.2.1 on my RV220W. I'd like to enable the UPnP service for automatic opening of ports as needed. According to the Admin guide the UPnP service can be enabled from the Firewall > Basic Settings > UPnP page, but I don't seem to...
I have a RV220W (running firmware 1.0.0.26) with the default VLAN 1 enabled. The LAN IP address is 192.168.22.1, with IP range 192.168.22.0/24. DHCP service is enabled with range 192.168.22.100-192.168.22.199. Inter VLAN is enabled for VLAN 1.I also ...
I am using an SPA525G with a 3CX PBX. Since I let the PBX handle the outbound rules, my dial plan on the phone is very simple: [x*].I have the 3CX Skype Gateway installed so I can call Skype user IDs. In the phone book on the phone I enter a number a...
Community Statistics
Member Since ‎01-26-2010 07:04 AM
Date Last Visited ‎08-18-2017 03:53 AM
Posts 13