About bagvanliju

bagvanliju · 02-27-2009

Hi,Customer is having network topology like this,Customer is having 2 Mbps link from Service provider which is connected to PIX,Customer requirement is how can he alocate bandwidth to 3 Departments using current setup....Note:One Department will requ...

bagvanliju · 02-25-2009

Hai,Was going thru some mpls documents...there was lots of confusion still,....abt ipv4,vpnv4...LDP ..(Types of LDP)...RT and RT value ...its going on ...can some one help me in understanding MPLS right from the basics....any gud link would be helpfu...

bagvanliju · 02-19-2009

Hi,One of my customer is facing strange issue.Total BW of the link is 20 Mbps 1:4,Customer is using full BGP route from service provider.Below is the config customer is having....As per customer BGP itself is taking 6 Mbps .....router bgp 16838 no s...

bagvanliju · 01-15-2009

Hi,ISP-ACC-RTR-XX>show ip cef | in Serial0/1/0.1/1/1/1:0XX.XX.XX.XX/30 attached Serial0/1/0.1/1/1/1:0XX.XX.XX.XX/28 attached Serial0/1/0.1/1/1/1:0Want to know the command in junper router for the abow output..is there any ...

bagvanliju · 12-18-2008

Hi,how can i config nat in router..using "Only WAN" ip.ISP has blocked entire /28 lan ip due to some span issue....for time being thought of using wan ip for NATing ... can some one help me in configuring the same ...would be very much appreciated .....

bagvanliju · 03-11-2009

Hi,Thanks for the reply,Yes its going over fiber,But exchange end there will be an Electrical drop were Master modem will be connected from there its going via "Copper" till customer premises."Means you have fiber till customer premise "No ... if fib...

bagvanliju · 03-11-2009

Hi,We have many customers which is not having MUX at their premises. As per customer requirement our vendor suggested E1 to Ethernet converter...this has tested and implemented successfully.. eg: customer requirement was 8 Mbps (there was no feasibi...

bagvanliju · 02-28-2009

Hi Joseph,Wah..its clear now ...thanks a lot once again,will discuss with the customer on monday and revet back with the status ujil

bagvanliju · 02-28-2009

Hi Joseph,Thanks for the detailed explanation.Very informative,But little confused about this term"configure proportional bandwidth sharing"..would be helpfull if you can elabrate some more on this.ujil

bagvanliju · 02-28-2009

Hi Mohammed,Thanks for the update,Will check the same with customer on monday and let you know the status.ujil

Member Since	‎08-18-2008 02:29 AM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	84
Total Helpful Votes Received	17

User Statistics

User Activity

Bandwidth segregation (Help)

MPLS Basics.Help

BGP Traffic 6 Mbps (URGENT)

Command comparision notes for cisco/juniper router

Need NAT commands (Urgent)

Re: T1 to Ethernet Solution

Re: T1 to Ethernet Solution

Re: Bandwidth segregation (Help)

Re: Bandwidth segregation (Help)

Re: Bandwidth segregation (Help)