Hello,
I'm new to the community and hoping someone can shed some light on my issue. I have a leased line coming in to connect two sites, Right now I have an ASA 5508-X that I'm preparing to use for one site.
The sites are set up as follows:...
This is not a true mesh topology.
At this point I don't mind putting a router behind the ASA and handling the routing there. I was reading an article that appears to be appropriate:
http://wiki-see.info/wp/category/firewalsl/cisco-asa/page/2/
I w...
Right now I have a basic router attached directly to the leased line interface. I can ping from inside the asa over the leased line interface to the SiteA.
My explanation was a little confusing. Since SiteA and SiteB are connected via the leased li...