Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I had a tunnel in a peer-to-peer using a 2 MB internet access. Now I need to increase to 4MB, but my service provider offers me two coax, so I will use two different serials with different IPs each, also, I will have two default gateways. I just trie...
I have a configuration using a private VPN.I have a 515 Firewall in which outside is connected to VPN in order to offer connection to the rest of the world. Inside connects a back-end exchange server and DMZ connects a frontEnd exchange server.I am u...
Actually I do have two questions: First is to know if it is possible to change the 100Full inside to auto or 10half in firewall 501. I am using version 6.3(4).Also, I need to confirm the other 3 port speed and if it is possible to handle speed as 10h...
I have a pix 515 in central site, in remote sites I have 501 models. All of them are using pppoe and I am using overload in outside instead of NAT, because only have a public IP address in each. Only in central site I have a static IP, but in the res...
I have two firewalls 501 and want to set up a vpn peer-to-peer. Firewalls are working OK with their policies for security but when implementing another access-list to set the traffic which will be encrypted, when I use the PDM again to add a new rule...
Thanks for your tip. Actually yes, I changed the remote peer to point to my loopback as destination and changed the crypto maps. What I didn´t use was the ppp mulyilink, I will try and will let you know.Thank you very much.
Yes, actually the problem was that in the front end servers I am using two ethernet cards,one goes to another firewall and the other goes to this DMZ so I had to use specific routes in these hosts to reach outside DNS services instead of using a defa...
Does somebody have a suggestion for my problem? I need to solve these issues:1.- I need to know why I cannot generate reports any more, I am able to perform complete report generation, system never sends any error message but it never shows the repor...
I do have VSM 2.2 and have generated several reports which I am able to display only when accessing equipment and going to security monitor-reports-view.Would like to know the path in my hard disk where these files are kepth.Thanks,
