About Joe-Jose

Joe-Jose · 08-02-2019

Here is the scenario, that i am faced with. There are two DCs. One is the primary and the other is secondary. Primary DC contains two vEdges and secondary contains one.All the vEdges in both these DC is connected individually to Internet and MPLS ie ...

Joe-Jose · 05-10-2019

Hi Everyone, I am in need to have an default route via an exit interface. ( example: ip route 0.0.0.0/0 Dialer10) how can we achieve this in Viptela. Even via Command line, i could not find any option. The above scenarios is based on IOS-XE SD-WAN 16...

Joe-Jose · 05-07-2019

Hi , I am trying to configure an ISR1117-4PLTE router with two simultaneous internet connection. 1) gigabit ethernet (connected to internet behind a NAT)2)LTE SIM (Internet via public ip) Is it possible to have all these interfaces up and running sim...

Joe-Jose · 08-02-2019

Yes, BFD sessions are there both via Internet and MPLS, but when internet is shutdown, both Internet and MPLS is apparently useless, as BFD on both these links are torn down.As with restriction, I haven't restricted the control-connection.

Joe-Jose · 05-12-2019

I am using PPPoA template and not PPPoE and the device that i have selected is C1111-4PLTELA. I am unable to find this function under these template. But the default route with the exit interface defintely worked for me and thanks for the solution.

Joe-Jose · 05-08-2019

Hi ekhabaro, I didnt realize that this is even a bug, when i started configuring VRRP , it was giving a message "Addition of virtual mac address not supported on this device on interface". But then i changed the adapter type from VMXNET3 to E1000 usi...

Joe-Jose · 05-07-2019

Hope you have upgraded the version. ? 18.4.1 software vedge works fine with VRRP. but you need to have E1000 interface. VMXNET3 interface will give an error "Virtual mac address cannot be created".

Member Since	‎08-28-2018 11:08 PM
Date Last Visited	‎03-01-2024 12:02 AM
Posts	7
Total Helpful Votes Received	10

User Statistics

User Activity

vEdge Traffic not failing over to MPLS Link

Default route via an interface on Viptela

SD-WAN ISR1100 LTE and Gig interface active

Re: vEdge Traffic not failing over to MPLS Link

Re: Default route via an interface on Viptela

Re: VRRP for Cisco vEdge cloud is not supported on E1000 and VMXNET3 I/O types from 18.3 version onwards. [CSCvn53200/VIP-48217]

Re: VRRP for Cisco vEdge cloud is not supported on E1000 and VMXNET3 I/O types from 18.3 version onwards. [CSCvn53200/VIP-48217]