Hi All,
Im wondering if someone can help me configure a way to make some IPs go through WAN1 and someothers IPs (from the same LAN) go through WAN2.
I did try with routing but still it uses both WANs.
Im using a Cisco AS520, this are my rout...
Hi All,
Im wondering if someone can help me configure a way to make some IPs go through WAN1 and someothers IPs (from the same LAN) go through WAN2.
I have been trying for long time now with no luck.
Thanks in advance!
Best regards,
Hi Seb,
I followed your recomendation but no luck.
here is my configuration:
The 2nd hope should be 192.168.36.1 (WAN2).
I checked my ip over the internet, just in case it where related to the protocol but not, it is still showing my ISP WAN1...
Hi Seb, thank you for your prompt response!
Im using a Cisco AS520, this are my routing options:
I did try with routing but still it uses both WANs.
I also tried IPv4 Rules with WAN Alias with no luck.
Any help would be very apreciated!
