Hello there,
I am using PCCE 11.02, and having issue intermittently that the CPU utilization going 100 %. Since there are chances for crash, kindly let me know how can i proceed further?
I have verified the following
1, Jtapigw process is using...
Can Anyone answer my below question?
1 How many call can handle by CVP PIM in comprehensive model?
2 In comprehensive model without SIP proxy server is possible to do load balancing? If so How we can implement it?
3 If one call get drop in between ...
I have upgrade my CUCM recently in my lab. My previous version was 10.5.1 and i have upgrade to 10.5.2. After upgrade none of the IP phone getting registred to my cucm. i have single system setup.Kinldy help me to resolve this issue.
Please verify the comparability matrix https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cust_contact/contact_center/crs/express_compatibility/matrix/uccxcompat11_6_2.html Rate my post if you found it is helpfull
Thanks for the update Sivanesan,
Sorry that i couldn't update you the path location on my previous update,
I already verified the same and the 32 bit version only installed on both PCCE callservers. We are getting issue only on single callserver(A)...
Hello sivanesan,
I am using below version CUCM, Also use the attached version of jtapi in my both call sever.
CUCM System version: 11.0.1.20000-2
Lemme know if you need any other information?
Thanks
nithin
Thanks suresh for your quick reply.
1 How many call can handle by CVP PIM in comprehensive model? -- cvp 10.5 supports up to 900 sip calls but it will depend on cvp port licenses.
I have gone through some documents. I can see some information rela...