About Raja_D

Raja_D · 02-17-2019

HI, I need small clarification on bgp unshut. I actually need to unshut a bgp peer ipv4 for a vrf Voice_data. While doing it, i did not get into the address-family ipv4 vrf Voice_Data to unshut the bgp peer 135.45.70.225 initially due to which I g...

Raja_D · 09-26-2017

Hi, Its pat overload query, can someone clarify Can't it be possible that we can be able to use the ip :192.168.50.24 from Network 192.168.50.24/29 for pat overload. Ex:Ip access-list standard 110 permit 10.51.12.1120 permit 10.51.12.1230 permit 1...

Raja_D · 09-25-2017

Hi, We have a dedicated DHCP server from which we are trying to get ip addresses polled to the PC's dynamically for which on the router we have the below configuration. DHCP Lan pool scope defined in the dhcp server is 10.56.12.112/28, GW is set to 1...

Raja_D · 09-22-2017

Hi, We have noticed a strange issue in one of our cisco 1800 router which has got two wan connectivities. Primary being the MPLS and Secondary being the ADSL connection. Ideally for all our existing setup's of this type we are able to login remote...

Raja_D · 08-22-2017

Hi, We have noticed frequent login attempt failure issue during specific time in one of our core device (cisco ASR1006) . We are able to get till the password prompt and when entered the password we get error as "Authorization failed" during that sp...

Raja_D · 02-18-2019

I figured it out on my own.. router bgp xxxxno neighbor x.x.x.x remote as xx This will just remove the ipv4 unicast peer bgp neighborship without interrupting the bgp peer neighbor x.x.x.x configuration that is under the address-family ipv4... Regar...

Raja_D · 03-24-2018

Mustafa, As per the configs that you shared, it makes me understand that your Internal LAN subnet is of 192.168.0.0/24 subnet , as you are trying to route your internal lan pool towards First ISP I suggest you to make below corrections in config. H...

Raja_D · 02-26-2018

Firstly it would not be possible for you to configure vlan 99 on L2 switch with ip 202.120.8.0 255.255.255.240 as its a network which holds the ip range from 202-120.8.1 till 202.120.8.14 and even if you try to configure vlan 99 on switch with ip 202...

Raja_D · 09-25-2017

Hi, Yes the DHCP scope is enabled in the dedicated DHCP server and able to ping the DHCP server with source as vlan. Also the gateway is configured in DHCP server, but the ip's are not getting detected by clients in network. Infact there was an acl o...

Raja_D · 09-23-2017

Hi, ip nat outside already exists on the Dialer2 interface and we also have the "access-list 50 deny any log" applied on acl 50. Actually i could see the matches showing up on the "access-list 50 permit y.y.y.y" when i try to attempt for a login fro...

Member Since	‎09-07-2015 11:11 AM
Date Last Visited	‎06-20-2021 11:53 AM
Posts	152
Total Helpful Votes Received	39

User Statistics

User Activity

BGP UNSHUT CLARIFICATION

PAT overload query

DHCP IP HELPER CLARIFICATION

ssh issue

Login issue

Re: BGP UNSHUT CLARIFICATION

Re: Dual ISP NAT - Route Specific IP

Re: Routers Configuration

Re: DHCP IP HELPER CLARIFICATION

Re: ssh issue