About jickly

jickly · 09-04-2018

Hello at all, I have two switches Cisco C3560 (Model: WS-C3560-8PC, Software version: 12.2(35)SE5, Software Image: C3560-IPBASE-M) and one Cisco ASA 5505. All three devices are in vlan 1 with these ip configuration: Cisco ASA: 192.168.254.254/24 SW...

jickly · 09-06-2018

The old ASA 5505 firewall model uses switch ports and vlan interfaces, and the Eth1 and Eth2 ports on the firewall are switch ports on the same VLAN.If I disable the Eth10 ports on the two switches they are seen and speak correctly through the Eth1 a...

jickly · 09-06-2018

but are you referring to the configuration of the ASA firewall or to the configuration of the switch?

jickly · 09-06-2018

HSRP is configured on vlan 1 interface on each SW. With "show standby" command I can see that SW01 is Active and SW02 is standby, and if I show logging I can't see error for HSRP. I can write more if necessary, show commands or running config...

Member Since	‎09-04-2018 01:42 PM
Date Last Visited	‎09-07-2018 12:03 AM
Posts	4

User Statistics

User Activity

HSRP and Cisco ASA

Re: HSRP and Cisco ASA

Re: HSRP and Cisco ASA

Re: HSRP and Cisco ASA