Hi,we are using cisco anyconnect for VPN to connect to our network. the authentication is through Radius server. The problem is that if a user who have access to vpn can download anyconnect to any computer at his home and able to connect. What i wan...
Hi,We have mpls setup btw 3 sites. i recently setup IPSec tunnel btw 3 sites for backup. Now if i shut the interface on my core where the MPLS router is connected, i lost the connectivity btw sites, even though i have setup static routes.E.gstatic r...
Hi,1. I am trying to setup a vpn connection between 3 sites (1 headquarter 2 branches).2. Also, i want to setup another vpn connection with a different site (abroad) by using same cisco 800 series router. Is above possible ? If yes, can someone pleas...
Hi,I have 3 three sites and want to setup VPN connection, any weblinks would be appreciated. Also, is this possible to setup multiple VPN tunnels with different sites from one router ? If yes, please give some examples. I would like to setup VPN conn...
I have cisco 3845 router. Currently we are using T1 line between two locations but recently we upgraded to TW Telecom Eline 4Meg. TW telecom handoff me an ehternet connection, they bundeled 3 T1 together. Now i want to use the existing t1 as it is b...
I had same problem but i configured VSS on 6807. I have used below commands to combine the power.
power redundancy-mode combined switch 1power redundancy-mode combined switch 2
well i have never seen that before and in my opinion its safe to remove. However, i would advise to wait for a little bit, see if anybody else respond.
