About Waterbird

Waterbird · 10-25-2023

I'm looking for a CLI command that can find the DHCP reservations but limited to a specific VRF.I know that 'show ip dhcp pool' is how to see these configured manual reservations (if they are configured).I know that 'show run | include hardware\-addr...

Waterbird · 05-24-2023

I would like to make a list of ideas for how to use an EEM applet on IOS/IOS-EX devices in a network for some beneficial purpose. Although I have a few ideas of my own, I want to expand my list and try new ideas. If possible, i would also like a lin...

Waterbird · 05-03-2023

It is my understanding that using "crypto key generate rsa" will generate two keys for use with SSH. One is a private key stored in NVRAM which cannot be accessed, and the other key is a public key. I believe this command should generate one general...

Waterbird · 05-02-2023

In an EEM applet I want to condition actions based on whether a show command outputs a result or does not output a result.Here is what I have come up with so far:conf tevent manager applet TEST event none! creating a variable with a temporary value ...

Waterbird · 02-23-2023

The first line of output of the "show logging" is: "syslog logging: enabled". Does this line indicate that all syslog globally is enabled, regardless of the individual status of various types of logging such as console, terminal, and trap/server log...

Waterbird · 11-07-2023

Thank you, but I'm wanting to get what manual reservations are configured, which I believe is not necessarily the same as what bindings there are.

Waterbird · 05-03-2023

Thank you for this solution. I tested it and I think there may be some slight modification needed to this script. action 4 if $var1 eq "" doesn't seem to work as expected. I get an syslog error that says %HA_EM-3-FMPD_UNKNOWN_ENV: fh_parse_var: coul...

Waterbird · 02-23-2023

Thanks, I'll try that command. By the way, how did you find that command? I searched the internet and could not figure out where to obtain that information. I often find it difficult to locate information on the output of specific commands for IOS...

Waterbird · 06-17-2021

I Can you please explain a bit more about why you reset the configuration register? And how I can tell what mine is currently set to? I was able to perform the write erase command, delete the backups, etc., However, I didn't do anything with the co...

Waterbird · 06-13-2021

Thank you this is perfect. With this device, though I am concerned, because thise device has an active and standby module. If the active module is wiped, could the standby module actually repopulate the configuration and restore it automatically? I...

Member Since	‎09-06-2018 03:12 PM
Date Last Visited	‎12-25-2023 11:13 PM
Posts	85
Total Helpful Votes Received	17

User Statistics

User Activity

IOS CLI command to obtain the DHCP reservations for a specific VRF

A list of EEM applet use cases

Clarification needed on key types generated by crypto key generate rsa

EEM applet conditional logic based on show command output

understanding the first line of the "show logging" output on IOS-XE

Re: IOS CLI command to obtain the DHCP reservations for a specific VRF

Re: EEM applet conditional logic based on show command output

Re: understanding the first line of the "show logging" outpu

Re: Procedure for wiping C3900-SPE250/K9

Re: Procedure for wiping C3900-SPE250/K9