About Mark99

Mark99 · 09-14-2018

I have 5 VLANs in my environment 1, 2, 10, 98, 99 and all is working fine (Layer 3 enabled, all interfaces and routes configured), I can ping any device from any VLAN. I've added an additional VLAN (20) for cameras and have configured it the same as...

Mark99 · 09-18-2018

I shows as up at 1Gb. I agree, there's something going on here that I don't get. As an aside, I configured everything using the web interface and only a few things with the cli. I had assumed that they both configured things the same way but... M...

Mark99 · 09-18-2018

I do have the port configured for VLAN20, I can't remove it from VLAN1.

Mark99 · 09-17-2018

When I attempted to ping the laptop's gateway (192.168.20.1), I saw no entry in the ARP cache. If I look at the dynamic mac address, it shows that it is in VLAN1 (which is the default one that every port belongs to). When I set the laptop to DHCP, ...

Mark99 · 09-15-2018

The port shows up and active with at 1 Gb (the camera shows the same except for 100Mb). Initially the camera showed up in the ARP table but after resetting the switch, there are not VLAN20 devices showing up. I'm not at the office right now so I c...

Mark99 · 09-14-2018

I didn't set this switch up originally so the rational as to why the ports are set the way they are escapes me. I know there were some issues sorting out the ip phones but again, I don't know what was done to resolve that issue. I have tried changi...

Member Since	‎09-14-2018 12:05 PM
Date Last Visited	‎09-26-2018 10:55 AM
Posts	7

User Statistics

User Activity

SG500 InterVLAN routing problem

Re: SG500 InterVLAN routing problem

Re: SG500 InterVLAN routing problem

Re: SG500 InterVLAN routing problem

Re: SG500 InterVLAN routing problem

Re: SG500 InterVLAN routing problem