Hello Experts,I have ISR 4461 router having 2 ISPs terminating with each has 1Gig internet bandwidth. We have failover on ISP circuits. We have below licenses pre-installed on the box.Technology Package License Information:---------------------------...
Hello, I am planning to procure couple of switches for our new office.On Access layer, I will have C9300 8 switches stack (6Nos. C9300-48P-A & 2Nos C9300-48UXM-A). I am also considering C9300-NM-2Y (2x25G SFP ports) uplink module in each C9300-48UXM ...
Hello Experts, I am currently facing an issue with etherchannel loosing connectivity with VMWare ESXi 6.7 host server. This is the new setup.So I have got 2 C9300 series switches (C9300-48UXM-A and C9300-48P-A) stack together. And 2 gig ports from C9...
Hello Experts, I am tasked to deploy a new Cisco 5516-X ASA (with firepower services) behind an existing Cisco router. Purpose of this addition is to setup remote access and IPsec VPN tunnels on the Cisco ASA. So it will be ISP => Cisco Router => Cis...
Hello Experts, I have Cisco 5516 ASA (Software Version 9.8(4)8) and we are undergoing requirement to build 2 IPSec vpn tunnels with same source and destination encryption domain but having different peer IPs. And we are requested to keep both tunnel...
@Georg Pauwen Thanks for responding. Please see the output below for the command you asked forSINSEA-WANRTR-01#show platform hardware throughput levelThe current throughput level is unthrottledWe do not have any performance license installed. See bel...
Yeah. I will have right licences in place. Will not be using breakout or QSA cables. All I am going to use are Cisco QSFP-100G-AOC1M= & Cisco SFP-H10GB-CU2M direct attach cables for SVL and DAD links.
Thanks for responding Balaji. The network is not too big but at the same time, I do not have any use of 100G other than SVL. So, I will go with 100G fixed ports for SVL and 10G fixed ports for DAD, on C9500-24YAC-A. Sounds good?
