About jonlopez

jonlopez · 04-27-2022

Hello everyone, We are currently investigating on how to do IP Communicator to Jabber migration of 400+ phones. Is there a way that I can migrate all the IP Communicator phones to Jabber but without deleting the IP Communicator phone? This way we can...

jonlopez · 02-20-2021

Hi everyone and thanks in advance. I have a site that has 4 POTS lines, but at that location there are two separate houses that share the lines for inbound/incoming calls. am trying to separate the lines for the houses that way 2x lines for House A a...

jonlopez · 01-08-2019

Hello all, I created a CTI Route point pointing to a Call Handler and which then transfers the calls to a Hunt Pilot and then to a group list. Currently on the Hunt list only two phones are assigned to it one being a 8811 and 7960 both using the mo...

jonlopez · 02-07-2022

Hi Shrijan, Were you able to solve the issue? I am having the same issue on my side. Thank you.

jonlopez · 02-23-2021

Hi Nithin, This was the first thing I tried but then realized that is only for CME. I got excited when I found it doing my research, but thank you for the reply.

jonlopez · 02-23-2021

Hi Roger, Thank you for the reply. Yes, we are using CM and SIP protocol for the gateway, and unfortunately the extensions are on the same block.

jonlopez · 10-23-2019

Can you share what was the resolution for your case? Thanks

jonlopez · 08-06-2019

Did you find a solution?

Member Since	‎09-18-2018 03:20 PM
Date Last Visited	‎10-06-2023 11:03 AM
Posts	10
Total Helpful Votes Received	5

User Statistics

User Activity

CIPC to Jabber migration

Outbound Dial-peer

ASCII Alerting Name not displaying on all phones

Re: Under AP Join it shows Ethernet MAC as 00:00:00:00:00:00

Re: Outbound Dial-peer

Re: Outbound Dial-peer

Re: UCCX License Issue After Reboot

Re: ISDN flapping