A PCM capture extraction tool is used by TAC to decode the PCM capture and get the audio files. I would recommend you to open a TAC case and get the actual audio files extracted. Hope that helpsRegardsNiteshPS:Pl rate helpful posts

Since the numbers are masked in the config, i couldn't find out where 4540700 is configured. Where exactly is 4540700 number configured? Enable 'debug isdn q931' , 'debug voip translation', 'debug voip ccapi inout' and make an outbound call. Check wh...

Just for testing can you try to block the translation pattern with Error=Precedence level exceeded, and then try a test call. If the call hits the Translation pattern, then the caller should hear an annunciator message as "Your call cannot be complet...

Check the CME roadmap belowhttp://www.cisco.com/en/US/docs/voice_ip_comm/cucme/admin/configuration/guide/cmeroad.html6911 is supported from CME 8.1Cisco Unified CME 8.18.1Toll Fraud PreventionEnables Toll Fraud Prevention on Cisco Unified CME to secu...