maybe this is a silly question.can I use two different supervisors and get full redundancy.for exemple a Supervisor V-10GE in slot 1 and a Supervisor 6-E in slot 2 ? or both supervisors need to be the same?my chassis is a 4507R (non-E)Sup V-10GE and ...
anyone can give me an hint on the sample configuration for both hob and spoke.I have found what I need between and ASA hub and IOS spokehttp://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a00807ea936.shtmlbut I al...
I have a project to build a short range link between two buildings about 800-900 meters (half a mile) away from each other using two 1250 in 802.11n mode. the design account for 2 external antennas on each side, 100 ft interconnects & lightning fuse...
the outside ip address of my PIX is dynamicly assigned from my provider DHCP server.is there a way to define and inbound acl to allow inbound traffic to go thru with port redirection.my problem is that if my outside dynamic address change from 64.1.1...
I also have nortel 2004 hansets I was wandering if could share your QOS configuration for a 4500 switch? I have been looking everywhere for information on that subject.
because I had only 800 meters between my sites. I finally decided to use BridgeWave SLE100. With this setup a I have a full duplex 100mbit/s wireless link. with FTP transfer I get a close to 10 Mbytes/s between two Windows servers
