About jdossey7

jdossey7 · 02-10-2011

We are trying to setup a C210 M2 and we are finding that with non-ECC RAM installed the fans run at around 5600 RPM. If we pull that RAM out and replace with ECC (with temp sensors), then the fans run normally - around 2200 RPM. The docs state that...

jdossey7 · 08-10-2007

We are having a small issue with a CME system with about 25 7931G phones connected to a PRI. All phones are configured so that button 1 is attached to the individual's DID, buttons 2-16 are incoming call DNs, and buttons 17-21 are parks. The proble...

jdossey7 · 04-15-2011

Here is the document that says that non-ECC RAM doesn't have temp sensors:http://www.cisco.com/en/US/docs/unified_computing/ucs/c/hw/C210M1/install/replace.html#wp1073477And we were not using Cisco RAM. We were using OCZ RAM part number OCZ3P1333C9L...

jdossey7 · 11-05-2010

Where do you download the 64bit TSP for CME?

jdossey7 · 08-16-2007

Pardon my ignorance, but may I ask what is the "Hlog button"?Thank you very much for you help.

jdossey7 · 08-16-2007

Thank you for your reply. I apologize if I use the wrong terminology for the CME config.In this case, the customer wants all of the phones to ring at the same time for all incoming calls. As I understand it, the ephone-hunt will cause the phones to...

jdossey7 · 08-16-2007

Here's a section of the config showing the ephone-dn's with the hunt group, and one of the ephone's. I cut out everything else. I'm not the Cisco engineer on this system. Our vendor set it up for us. They said there was no way around this particu...

Member Since	‎03-05-2007 06:58 AM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	7

User Statistics

User Activity

C210 M2 Fan Speed too high with non-ECC RAM

CME 7931G phones and "Hold Focus"

Re: C210 M2 Fan Speed too high with non-ECC RAM

Re: CallManager Express TAPI TSP Windows 7 64bit

Re: CME 7931G phones and "Hold Focus"

Re: CME 7931G phones and "Hold Focus"

Re: CME 7931G phones and "Hold Focus"