About GregMc

GregMc · 02-18-2022

Hi.I'v got a service provider to do some P2P Layer-2 ONLY links for me.They have a requirement to send traffic to them(the provider) from 1 of my end points using 802.1p.MTU available is 9100 bytes over the provider link. The P2P provider will only a...

GregMc · 10-17-2018

Hi I have a requirement to implement an IP-Sec service like the attached pic. Due to a 3rd party LAN that carries traffic I would like a IPSec tunnel between two routers. The end users will need internet ( NAT to say a 192.168.1.x). Does anyone have...

GregMc · 10-22-2018

My final solution after days on this was to use Dynamic Multipoint IPsec VPN as described in :https://www.cisco.com/c/en/us/support/docs/security-vpn/ipsec-negotiation-ike-protocols/41940-dmvpn.html..I did note that there is a LOT of OLD doco out th...

GregMc · 10-17-2018

I will further investigate the tunnel/ipsec option today. That said, as its for a production environment I need to get this exact. I haven't had to do something like this before, so its a bit of a learning curve for me !

Member Since	‎10-17-2018 05:02 AM
Date Last Visited	‎02-19-2022 10:22 PM
Posts	4

User Statistics

User Activity

802.1p VLAN CoS output change on a 2960X/ME3400

IPSEC Lan to Lan to Internet

Re: IPSEC Lan to Lan to Internet

Re: IPSEC Lan to Lan to Internet