digi076
Level 1
Level 1
Member since ‎10-28-2018
‎03-06-2020

User Statistics

  • 14 Posts
  • 0 Solutions
  • 5 Helpful votes Given
  • 0 Helpful votes Received

User Activity

Hello all,I'm facing a challenge regarding mounting of the AIR-AP1572EAC-E-K9 onto a light pole with a diameter of 52cm. According to the ordering guide, the AIR-ACCPMK1570-2= Wall or pole (2 to 16 inches in diameter) with tilt adjustmentsupports up ...
Hi all, Within GNS3 I have succesfully created a DMVPN phase 3 topology with 1 HUB and 2 Spokes and all works well.I'm building a DMVPN topology with "real routers" but I get stuck.On the spoke there is no output with the "sh ip nhrp" command.At leas...
Hi all, I've read a lot of discussions about Hairpin NAT for Cisco IOS router. Mostly about creating an NVI, PBR or split DNS.On my Mikrotik home router I was facing this issue as well but it was easy to enable a Hairpin NAT solution, seehttps://wiki...
Hey guys,   We have a test lab in our office where we used to work with a Cisco 887va on a VDSL circuit. Now we have a new setup with a Cisco ISRC1117-4PLTEEA on the same circuit.  The latter is using IOS-XE.   Everything works fine except for the vo...
Hi all,   We have a lot of setups with Cisco 887va VDSL separated by a data EVC and Voice EVC. This is tagged traffic and thus created 2 subinterfaces on ethernet 0. These connect to dialer1 and dialer2 respectively. Most networks are relatively simp...
Community Statistics
Member Since ‎10-28-2018 07:09 AM
Date Last Visited ‎03-06-2020 12:07 AM
Posts 14
Helpful Votes Given To