About gneslim

gneslim · 11-29-2020

What are the technical differences between the TLS Proxy actions "No Decrypt" and "Pass Through" in Cisco SDWAN? Attached the screenshot below. There has been very little to no explanation in the docs and hope to get better elaboration here.

gneslim · 04-15-2011

Hi, I am running a test scenario as described below to bring up 6PE, connecting 2 IPV6 islands over a MPLS core.All routers run the same IOS (Dynamips)PE1#sh verCisco IOS Software, 7200 Software (C7200-SPSERVICESK9-M), Version 15.0(1)M, RELEASE SOFTW...

gneslim · 12-22-2010

Hi,I am currently setting up a LACP port-channel on the Cisco 6509 (SUP720-3BXL with the following modules:NAME: "6", DESCR: "WS-X6348-RJ-45 48 port 10/100 mb RJ45 Rev. 6.1"PID: WS-X6348-RJ-45 , VID: , SN: XXXXXXXXXXXNAME: "7", DESCR: "WS-X6548...

gneslim · 10-17-2010

Hi,I am having issue understanding after a read on the route-map continue clause works based on Cisco's explanation.http://www.cisco.com/en/US/docs/ios/12_3t/12_3t2/feature/guide/gt_brmcs.html#wp1045836There are two behaviors that can occur when the ...

gneslim · 12-04-2020

Hi, If your vManage and vSmart devices do not have access to the internet, the alternative for vEdges to talk to them will be through reverse-proxy. This configuration can be found in Administration --> Settings screen. If configured properly, it wil...

gneslim · 11-29-2020

Hi, Is the interface being configured as a last-resort-circuit? If the interface is configured as last-resort, it will not come up as long as any other WAN interface is active.

gneslim · 10-13-2020

Hi,The error message you're getting seems to signal that you're trying to configure interface eth0 in both VPN0 and VPN512. That is not an acceptable configuration because a layer 3 interface can only be placed in one VPN. Running config doesn't look...

gneslim · 10-12-2020

Hi, Is this installation done from ESXI or KVM? Importing the vManage OVA initially will be configured with a 20GB disk for vManage system usage. Subsequently a 100GB disk should then be created for database. As for your case, you may need to review ...

gneslim · 10-07-2020

Before version 20.1, the maximum number of SLA classes was 4. With 20.1 release, the maximum number of SLA classes that can be applied to the vSmart controller is increased to 8. Link to 20.1 release notes (See "What's New for Cisco SD-WAN Release 20...

Member Since	‎10-17-2010 06:29 PM
Date Last Visited	‎12-06-2020 08:22 AM
Posts	19
Total Helpful Votes Received	35

User Statistics

User Activity

SDWAN TLS Proxy Actions

Configuring 6PE

Help configuring LACP on the 6509

Route-map continue clause

Re: SDWAN-On Premises-SETUP

Re: SDWAN Control connections issue

Re: vManage interface config error message - values are not unique: eth0

Re: vManage

Re: SD-WAN max SLA classes