Hi everyone, How to import VRF route-table to Global route-table For example:R1#sho ip routeCodes: C - connected, S - static, R - RIP, M - mobile, B - BGPD - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter areaN1 - OSPF NSSA external type 1, N2...
Hi everyone, Here is my topo: SW4----------(T1/0/6)SW3(T1/0/9)----------SW2 | (T1/0/11 Block) | |-------------------SW1 Here are the flapping log:*May 15 ...
Hi everyone, I have a 802.1x problem here.I hoped the PC while authentication fail dynamically allocating to guest vlanBut it turned to be drop not be assigned to the dedicated guest vlan c3560#sho mac add int fa0/13Mac Address Table---------------...
Hello everyone, I found several ports blinking orange all the time. The other ports are blinking green normally. GigabitEthernet2/0/11 is up, line protocol is up (connected)Hardware is Gigabit Ethernet, address is 2c86.d219.638b (bia 2c86.d219.638b)D...
Hi all, Our C3850 in stack which version is 16.6.5. The cpu will high periodictity.I have read some document . sw-241#sho platform software fed switch active punt cause summaryStatistics for all causesCause Cause Info Rcvd Dropped--------------------...
Thank you for your reply.When I changed host-mode from multi-auth to multi-domain or single-host .It could moved into vlan 31.What difference between multi-auth and multi-domain ?What cause it be droped When useing multi-auth.As my knowledge, if use ...
Thank you for your reply.I have shorten [tx-period] ,but didn't work .It still dropping interface FastEthernet0/13description dot1xswitchport access vlan 21switchport mode accessauthentication event no-response action authorize vlan 31authentication ...
I mean I have disabled the 802.1x on the PC not interface,because I wanted the PC authenticate fail so that the PC would be assigned to guest vlan!the configuration of interface as below: !interface FastEthernet0/13switchport access vlan 21switchport...
