Hi guys, hopefully someone can help or give a hint. I have a core switch Network of 4 switches connected in a ring. SW1 and SW2 are doing hsrp and take over layer 3 functionalilty SW3 and SW4 are only layer 2 SW1 VLAN 5 10.1.1.2/24 - SW1 VLAN 6 10.1.2.2/24 SW2 VLAN 5 10.1.1.3/24 - SW2 VLAN 6 10.1.2.3/24 SW3 VLAN 5 10.1.1.4/24 SW4 VLAN 6 10.1.2.4/24 VLAN 5 standby IP 10.1.1.1 - VLAN 6 standby IP 10.1.2.1 So SW1 and SW3 belong to VLAN 5 Management and SW2 and SW4 bolong to VLAN 6 Management issue: SW3 can ping within it's subnet but not to SW4 with 10.1.2.4 in VLAN 6 SW4 can ping within it's subnet but not to SW3 with 10.1.1.4 in VLAN 5 then we have an Access switch (sw5 VLAN 5 10.1.1.5) with only layer 2 which is connected to SW1 and SW2 and this sw5 can ping within it's subnet and to VLAN 6 SW2 10.1.2.3 but not VLAN 6 SW4 10.1.2.4 I guess there's a Routing issue but I have no idea at the Moment. Output sw5 sw5# traceroute 10.1.2.3 Type escape sequence to abort. Tracing the route to 10.1.2.3 VRF info: (vrf in name/id, vrf out name/id) 1 10.1.1.2 3 msec 0 msec 4 msec 2 10.1.1.3 3 msec * 0 msec sw5# traceroute 10.1.2.4 Type escape sequence to abort. Tracing the route to 10.1.2.4 VRF info: (vrf in name/id, vrf out name/id) 1 10.1.1.2 3 msec 14 msec 4 msec 2 * * * 3 * * * Output SW3: SW3#ping 10.1.2.1 Type escape sequence to abort. Sending 5, 100-byte ICMP Echos to 10.1.2.1, timeout is 2 seconds: ..... Success rate is 0 percent (0/5) sw3#traceroute 10.1.2.2 Type escape sequence to abort. Tracing the route to 10.1.2.2 VRF info: (vrf in name/id, vrf out name/id) 1 * * * made you short paint drawing for an overview. any advise?
... View more