I have a strange issue here. I have a branch router that I just deployed, connected via DMVPN. The DMVPN tunnel builds just fine. Once the tunnel is up, the branch router gets all the routes via EIGRP from the core. However, the core routing tabl...
I have a 4506 switch that I am having difficulties connecting to. My end-user traffic is passing through just fine. If I'm on another switch in my environment I can SSH into this switch. I can ping the management IP from any other switch in my env...
I am trying to setup a DMVPN with a single hub and two spokes. I have them up and running, and the ISP link is 400\200 on both ends. However, when I check the speeds over the tunnel I am getting 10\8.We have an ASR 1001 as the hub, and we started w...
It's been a little while since this thread stalled. I've just been too busy to get around to replying what happened. Turns out I was just being a dope. I've been so used to connecting everything together (router, switches, endpoints) during my dep...
They're all active already, they're just down and down. I did run that command on the management vlan, but it didn't change anything. I'm guessing I'll just have to connect something to it in order to bring the SVIs up. I'll let you know when my de...
The physical interfaces are down because there are currently no other devices connected to this L3 switch. I am waiting on another device to arrive. One of the SVIs is my management VLAN though. Is there no way to get this to come up without havin...
Well, they're down, but not administratively down. show ip int briefInterface IP-Address OK? Method Status ProtocolFastEthernet0 unassigned YES unset down downFastEthernet1 unassigned YES unset down downFastEthernet2 unassigned YES unset down downFas...
