Is it possible to tftp from an edge / border switch within the DNA fabric to a tftp server outside the fabric?I am wanting to backup the switch configs, but the tftp connections are failing (timing out).I can do this successfully from the fusion rout...
We no longer use SNMP v2 and now use SNMP v3 in DNA .(The v2 community strings were removed from the switches and the v3 settings applied insteadAfter re-running discovery, the devices are detected and managed using the v3 credentials.However, Assura...
I have always backed up the startup / running config of cisco switches with copy start (or run) tftp.This then prompts for 'address or name of remote host' (supply IP address of tftp server)after that, it prompts for the file name and then copies the...
Thanks for your replies The edge / border switches can ping the tftp server and vice versa - both underlay and overlay addresses, so routing exists.we have multiple sites connected via MPLS. At present we are only implementing DNA on a site by site b...
Thanks. We had a call with cisco TAC and I think they are planning v3 support. In relation to the original post, we had to restart the snmp service from cli in order to pick up the new v2 credentials for assurance as it wasn't happening automatically...
I think 'semi-colon' is a typo. It should be a colon immediately after tftp Older ios accepted:Copy run tftp The newer ones required:Copy run tftp: Hope that helps
