I have a working 7942 IP phone connected to a working 561 headset. All cables are connected. The headset and phone don't see each other. I browsed my phone settings and found Headset Hookswitch Control "Disabled". The only management program I have i...
Hello everyone. We just bought a Cisco 561 headset. The headset itself works great since you can connect it to a computer via USB. But, we have a Cisco IP phone 7941 running 9-4 firmware. When this headset is plugged into that phone it doesn't seem t...
Cisco Wifi (VLAN30, 172.16.30.254)----Cisco Router(10.10.10.254)----Sonicwall (10.10.10.250) I have a Cisco wireless AP. I can connect to it with any wireless device. I am getting an IP from the Cisco Router which is giving vlan 30 the subnet 172.16....
When I open Cisco Configuration Assistant i get a startup error. Please see the attached image.I tried to install the latest version of Java, but that didn't help. I also noticed that when i logged into a different computer with this Cisco software i...
I have a Cisco wireless AP. It's configured for Vlan 1 and Vlan 30. Vlan 1 is our internal subnet. Vlan 30 is the "Guest" network. I've worked my way through the switches to make sure the Guest Vlan is configured. It is on certain ports. The router i...
Question #1 - Yes.This is the output of show IP route: Gateway of last resort is not set10.0.0.0/8 is variably subnetted, 7 subnets, 3 masksC 10.1.1.0/24 is directly connected, Vlan100L 10.1.1.1/32 is directly connected, Vlan100C 10.1.10.0/30 is dire...
Our Sonicwall has a single line coming from the router. X0 is setup for the 10.10.10.x subnet. How would I setup VLAN30 (172.16.30.x) to have access through that interface?
It seems the access list is already setup for any:UC560#show access-listsExtended IP access list 10010 deny ip 192.168.10.0 0.0.0.255 any20 deny ip host 255.255.255.255 any30 deny ip 127.0.0.0 0.255.255.255 any40 permit ip any anyExtended IP access l...
Thank you for the reply. The info is pasted below: UC560#ping 10.10.10.254 source vlan 1Type escape sequence to abort.Sending 5, 100-byte ICMP Echos to 10.10.10.254, timeout is 2 seconds:Packet sent with a source address of 10.10.10.254!!!!!Success r...
