About ReedMikel1

ReedMikel1 · 11-17-2020

I have a RV260P with latest firmware (1.0.01.01). I have several Access Rules defined and enabled to block some Source IP Ranges. One example is 149.11.0.0 to 149.11.255.254. I also have unchecked the Access Rule's "Log" box. My assumption is tha...

ReedMikel1 · 01-22-2019

Can anyone advise where to enable remote admin (http or https) over WAN? Closest I've found is under Security->TCP/UDP Services. By default it lists HTTP [x] Enable and HTTPS [x] Enable, and in the TCP Service Table list is shows HTTP State=Listen,...

ReedMikel1 · 01-22-2019

Hi All,I have 5 relatively new (3/18) SG250-26P switches that all exhibit the same quirk where shortly after I log into the web management GUI it will display the flashing "Save" button along top. Yet I made no changes. I did make changes earlier, ...

ReedMikel1 · 11-17-2020

My bad - I wasn't paying attention to the fact that I was only blocking that IP range if it was Source. It was DST in the log...

Member Since	‎01-22-2019 12:56 PM
Date Last Visited	‎11-18-2020 09:23 AM
Posts	4

User Statistics

User Activity

RV260P: System log list a firewall block even though Access Rule has Log unchecked

SG250-26P: setting to allow remote admin over WAN?

SG250-26P switches: display "Save" button even though nothing has been changed

Re: RV260P: System log list a firewall block even though Access Rule has Log unchecked