About cireddy334

cireddy334 · 05-03-2011

Hi, I am running VRRP on Cisco 2811 router (Cisco IOS Software, 2800 Software (C2800NM-ADVENTERPRISEK9-M), Version 12.4(15)T1), with another device.i am getting following error message "VRRP: Header ip address count sanity check failed" on Cisco rout...

cireddy334 · 04-27-2011

Hi,I am new to Cisco products, i have Cisco 2811 router (Cisco IOS Software, 2800 Software (C2800NM-ADVENTERPRISEK9-M), Version 12.4(15)T1, RELEASE SOFTWARE (fc2))I want to know how to configure PPPOE on one the interface and hosts connected on ther ...

cireddy334 · 05-04-2011

Any information on this one is really helpful.With Regards,Channareddy

cireddy334 · 04-28-2011

This is access list what i had it initially access-list 1 permit 172.16.10.0 0.0.0.255This was not working and then i went for static nat. I forgot to mention it in my prevois mail.-Channareddy

cireddy334 · 04-28-2011

Thanks Juan for your prompt reply and valuable input on the subject . I just want to report an issue that i see with nat .. I observe that the static nat is working in my secnario but the dynamic nat is not working. Here is my config.Router#show runR...

cireddy334 · 04-28-2011

Thanks the recommended configuration is working!-Channareddy

Member Since	‎07-04-2008 06:40 AM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	6

User Statistics

User Activity

Need info on "VRRP: Header ip address count sanity check failed" message

Need Support For PPPOE to access internet

Re: Need info on "VRRP: Header ip address count sanity check fai

Re: Need Support For PPPOE to access internet

Re: Need Support For PPPOE to access internet

Re: Need Support For PPPOE to access internet