Hello I have the following configuration on a subinterface and I what to remove the RIP configuration from it.
interface TenGigabitEthernetx/y/z.100
bandwidth 20000encapsulation dot1Q 1234vrf forwarding vrf-nameip address 1.1.1.1 255.255.255.252ip fl...
Hello,I am trying to implement in my lab a vrf aware ipsec. There is something that I am missing in my configuration, but I cannot identify it. Attached the configuration I am trying to implement on both routers.On the same routers I have managed to ...
Hello.I would like to ask if it is possible to configure, on a cisco router, Active Direcotry authentications for SNMP v3.The cisco routers are 1841 / 1921 / C891-FThank you in advance.
Hello. I am trying to install a certificate on a Cisco 5508 Wireless Controller. As a guide I am usinghttps://knowledge.digicert.com/solution/SO25990.htmlThe generation of certificate works fine. And I see that Cisco 5508 does connect to the TFTP ser...
Hello,
I see this on all interfaces. So it might be as you have specified yes.
So the configuration itself is inherited?
Meaning that I cannot remove it with the command I am using?
Best regards!
I have managed to make it work. However, I do not understand why I cannot send traffic from the LO interface. It worked after creating a VM and connecting it into the router, in to that specific VRF. I had to remove the LO interface and create a phys...
