About draj

draj · 08-21-2020

Hi, Community, I am still at learning stage, highly appreciate if someone help me in static routing. My static routing in packet tracer is not working with attached topology. The Router_1 does not shows any static routes though I've configured and sa...

draj · 07-12-2020

Hi Experts,I would like to check, would it be possible for us to connect 2 ISPs(Point-Point or WAN) to CISCO 2960-X for 2 systems?. Attached sample network diagram. Please advise.Much appreciated in advance.Regards,draj

draj · 06-06-2020

Dear Community Experts,As I am new to networking, seeking your valuable advice to clarify some doubts in networking. The scenario, current setup that we have in our local site 3 VOIP communication systems, and the requirement was I have to move one o...

draj · 06-02-2020

Hi Experts,Newbies seeking specialists advise, I am having catalyst 2960-X series switch and it's been configured to bring one up-link via ISP to the remote site. Is it possible to configure for 2nd up-link through another ISP vendor for next remote ...

draj · 06-25-2016

Hi to all, I am trying to configuring cisco catalyst switch 3850, everything is fine except encapsulation dot1q. when i tried to configure encapsulation no command available to proceed further to config dot1q. any one can advise me is that command av...

draj · 08-23-2020

Hi,In PT, this thing happened if missed the "dns-server" command in router configuration when the IP dhcp pool enabled to obtain IPs and we need to tell the router while creating the DHCP pool what is our dns server. you may add it later but if do so...

draj · 08-22-2020

Hi,Much appreciated for help and the time invested for me. Static routing is working now with default route :). Can I take a chance to clear my doubt on VLANs over the WAN(internet) with same topology, would it be possible to bring over multiple VLAN...

draj · 07-14-2020

Hi, Deepak Kumar,Thank you for the clarification.This is to achieve the client at B-end should be able to receive automatic voice broadcast messages from the A-end thru the ISP1 or vice-versa and the needs of the ISP2 to receive the data signal from ...

draj · 06-06-2020

Thank you for your reply.I believe the WAN speed would be 10mbps since the system required around 6mbps.I am not sure about the budget details, it might be the cheapest one, please.Thank you

draj · 06-05-2020

Hi Georg,I greatly appreciated your help. I hope this will work as one of the clients want to implement the above set up.Thank you so much again.

Member Since	‎06-24-2016 11:34 PM
Date Last Visited	‎08-26-2020 12:08 AM
Posts	12
Total Helpful Votes Received	1

User Statistics

User Activity

Packet tracer-Static route not working

Does the CISCO 2960-X supports 2 ISPs for 2 different application?

How to bring VOIP system's connection to remote site over WAN?

Can the 2960-X series switches support 2 up-links through 2 different ISP?

Unable to encapsulation dot1q on catalyst3850

Re: Host name unresolved

Re: Packet tracer-Static route not working

Re: Does the CISCO 2960-X supports 2 ISPs for 2 different application?

Re: How to bring VOIP system's connection to remote site over WAN?

Re: Can the 2960-X series switches support 2 up-links through 2 different ISP?