Hello Experts,
I was configuring an INE full scale lab for the CCIE preparation and I faced the following problem with Multicast.
The idea is to have multicast traffic being R3 the source, R9 the receiver and R7 the RP. The ISP (R4, R5) are not m...
Hello all,
I am trying to set up a MPLS with BGP core, using confederations in order to have the iBGP full mesh. While configuring it, I faced this situation
R1 establishes an eBGP connection with R2
R2 establishes an iBGP connection with R3
...
As Claudia said the BD settings are mostly dependent on the type End hosts connected to that bridge domain. That said, if “silent hosts” are connected you should enable flooding on the BD.
However the ACI Fabric also uses ARP Gleaning and sends pro...
Hello,What do you mean by a BD in a L3OUT configuration? You mean a BD that is associated with a L3Out. In that case, most probably you have ‘unicast routing’ enabled and a Subnet configured, therefore is should be fine to Disable ‘ARP Flooding’ and ...
Hello,
Have you tried to create the contract in the user tenant?
Please also try to create the 'Device Selection Policies' in the User Tenant. Avoid using the Wizard
Hello,Yes, VXLAN is only an overlay protocol. It does not care about which topology you have in the Underlay as long as you have VTEP reachability. Normally clos topologies are used for the sake of redundancy in the underlay. As an example in ACI we ...
Hello
You should have a look at at the VMM integration with AVE. This integration natively uses VXLAN packets between the Fabric and the Hypervisor virtual switch. Thus the only VLAN you will need to enable in your UCS infrastructure, namely the FI,...