About eng.akram.iq@gmail.com

eng.akram.iq@gmail.com · 02-24-2019

Hello , i have problem when i want to config limitation configuration on interface tenGige in Router NCS 540 appear this massage below :NCS540#CONFMon Feb 25 06:09:22.673 UTCNCS540(config)#policy-map 54STM-defaultpolice rate 8397 MBPSNCS540(config-p...

eng.akram.iq@gmail.com · 02-26-2019

Thanks , i wrote the guide but i have misunderstanding with this command :police rate percent 20 burst 10000 bytes can you please explain it , where I put number of limit Traffic ?if i have interface TENGigE and i want limit its traffic to 54 stm how...

eng.akram.iq@gmail.com · 02-26-2019

OK, but the router reject already the service-policy command !! how can I do what you write if i didn't put service-policy already in the router ?thanksAkram

eng.akram.iq@gmail.com · 02-25-2019

Thank you to your response below what you want to shear : NCS540(config)#show configuration failedMon Feb 25 10:50:20.047 UTC!! SEMANTIC ERRORS: This configuration was rejected by!! the system due to semantic errors. The individual!! errors with ea...

Member Since	‎02-24-2019 10:35 PM
Date Last Visited	‎03-01-2019 02:02 AM
Posts	4

User Statistics

User Activity

how can i make limitation in interface in router NCS 540

Re: how can i make limitation in interface in router NCS 540

Re: how can i make limitation in interface in router NCS 540

Re: how can i make limitation in interface in router NCS 540