About mparham6

mparham6 · 08-22-2019

Current architecture/config is described in picture below. My issue is that I'm unable to ping Host B from Host A, and vice-versa. The two radios pictures are configured as a bridge. If I add Host A's MAC address statically on VLAN 42 associated w...

mparham6 · 04-30-2019

Hi all, I'm wondering if it's possible to tunnel VLAN's across a single switch? I made a quick drawing of what I'm working with in my environment. The two radios are networked together via an Over The Air (OTA) link. I'm using an Ixia traffic gene...

mparham6 · 03-04-2019

I have two ports configured on a switch, one being an access port for VLAN 10, the other being a trunk port. Should two hosts (one connected to the access port, the other connected to the trunk port) be able to talk to each other? Specifically via ...

mparham6 · 08-29-2019

"I don't know why you would like to have two Radios on the same switch I don't see a practical use case for this." -> I'm testing the capabilities of the radios in this network. The two hosts on either end are being used to test host-to-host traffic...

mparham6 · 08-26-2019

Hi Giuseppe, thanks for the reply!So I know for a fact that this will work if using your suggested setup, but unfortunately due to certain limitations I absolutely need to try and get this working across one physical switch.Is there a way to exclude ...

mparham6 · 08-26-2019

Unsure what you mean by "disable one of the radios". I broke the RF connnection between the radios and the loop stopped. Not sure if that answers your question?

mparham6 · 08-23-2019

Hi Reza, Thanks for the reply! I'm currently VLAN tagging from the hosts themselves (the NICs are VLAN tagging capable). Additionally, the trunk ports are configured due to the fact that in other configurations I'm able to route traffic across this...

mparham6 · 05-01-2019

Thanks for the replies! Unfortunately the issue is that with the radios containing the same exact networking configs information generated by my test tool is being sent to both radios. Perhaps I'm not explaining it well enough, but I do believe there...

Member Since	‎03-04-2019 08:45 AM
Date Last Visited	‎10-25-2019 12:02 AM
Posts	9

User Statistics

User Activity

Layer 2 Switching Loop

Q-in-Q On Single Switch

Access and Trunk Port Communication - SNMP

Re: Layer 2 Switching Loop

Re: Layer 2 Switching Loop

Re: Layer 2 Switching Loop

Re: Layer 2 Switching Loop

Re: Q-in-Q On Single Switch