Hi,I am some questions in relation to (https://supportforums.cisco.com/thread/2230776)I have a pair of n5K (A & B) running vpc with VPC Portchannel (e.g 10) uplink to core switches running VSS. my downstream VPC Portchannels (e.g 20) to servers/enclo...
Hi,may i ask if we use cisco telepresence video conferencing in office,1) multiparty (assume 5 internal users) VC within the office, is it unicast/multicast traffic?2) VC party include another 2 users at our remote office connected via MPLS (Total 7 ...
Hi All,i bought the wrong interface cards vwic3-1mft-e1/t1 and it is not working when my vendor trying to set it up.Need some advise from you guys, if it is possible to configure the e1/t1 card to run on this g703 unframe link? understand the con wil...
Hi all,may i ask if the AP is able to configure 2 public ip address of the DMZ-WLCs?like ip 1.1.1.1 in my US data center, whereas a second ip 2.2.2.2 in my EU data center?
Hi Gurus,I have a question regarding the use of distribute list out to only advertise deafult route to certain eigrp neighbor.Current Scenario: i have 3 routers sitting in a same vlan1 on the switch running eigrp. Name them A, B & C. I need to advert...
Actually it did happen to our DC in early january that N5K-A has all the 32 ports down and we rebooted that unit to restore it.The peer keepalive link is working because it is using the mgmt interface. therefore N5K-B will shut down all its PO ports ...
Hi Paolo,so what i need to do are:1) ask the local loop provider to change the 3 x NTU settings from unframed to Framed.2) ask the PE router provider to configure their 3 x G703 cards to use timeslots as well.doing the above at least can get my circu...
I see. ok thanks. that means i can only make it points to one of the WLC in either US or EU datacenter.if lets say i point it to US datacenter.. and i have a pair of WLC in the DMZ, since i can only point to one of it, is it redundant to have a pair ...
Hi George,Thanks for the reply. what you mentioned is after the AP connected to the WLC (the public IP configure on the AP during the initial setup).what i wish to achieve is something before that, that is to say if the AP fails to connect to the 1st...
