I tried for hours, but I couldn't. I gave ip adress pc and vlan1, but doenst work. When i write "show interface status" everytime i seem notconnected. where is the problem i want understand.

I gave the IP Adress, Gateway and Dns,  PC1 and PC2.After ping. But doesnt work show mac address table command.

I would like open switch console and use the command enable  show mac address-table but doesnt work.

I continue working from CCNA-Routing-and-Switching-ICND1-100-105-Official-Cert-Guide for Cisco CCNA exam. However, I can't make many examples of packet trackers.I'm thinking about making other program usage (GNS3) examples, but which program (packet ...

I would like use example 7-6 in the CCENT/CCNA ICND1 100-105 Official Certification Guide book.This command doesnt work; show mac address-table dynamic vlan 1