Hello to the community.
I have this topology:
The green devices are switches layer 2, the blue devices are switches layer 3.
I use the VLAN250 as transit network, the green devices has only the vlan250 (L2) permitted on every trunk:
SWT-A:
rou...
The issue is related to the routing table,
no one receive the networks from SWT-A and the network of SWT-B 192.168.253.0/24.
I also notice that, even the network is in routing table, I'm not able to reach the 192.168.254.100 (host on SWT-D).
I'm ab...
SWT-C:
Vlan250 is up, line protocol is upInternet Address 10.250.0.6/24, Area 0, Attached via Network StatementProcess ID 1, Router ID 192.250.0.1, Network Type BROADCAST, Cost: 1Topology-MTID Cost Disabled Shutdown Topology Name0 1 no no BaseTransmi...
Yes, the interface is UP/UP.
SWT-A:
Vlan250 is up, line protocol is upInternet Address 10.250.0.1/24, Area 0, Attached via Network StatementProcess ID 1, Router ID 192.250.0.254, Network Type BROADCAST, Cost: 1Topology-MTID Cost Disabled Shutdown T...
Yes, the interface is UP/UP.
SWT-A:
Vlan250 is up, line protocol is upInternet Address 10.250.0.1/24, Area 0, Attached via Network StatementProcess ID 1, Router ID 192.250.0.254, Network Type BROADCAST, Cost: 1Topology-MTID Cost Disabled Shutdown T...
Yes, the interface is UP/UP.
SWT-A:
Vlan250 is up, line protocol is upInternet Address 10.250.0.1/24, Area 0, Attached via Network StatementProcess ID 1, Router ID 192.250.0.254, Network Type BROADCAST, Cost: 1Topology-MTID Cost Disabled Shutdown T...