Hello,I have two 504G phones behind NAT gateway to a service provider. One of the phone works for incoming/outgoing. Second phone works for outgoing but not incoming ...Are there set of instructions avaiable for behind NAT scenarios ? I have used the...

Hello,I am trying to upgrade SPA 504G using the utility that is bundled in the package, from computer which is connected on its LAN port (same subnet). Current version is  7.4.8 and tying to upgrade to latest 7.5.1I can open the GUI, ping it, but thi...

Hi All,I have calls coming via SIP trunk in a 2611xm router that has 4 FXO lines for dialing out to campus exchange. The setup is working for both inbound and outbound calls. Users are dialing a standard pattern e.g. XXXX , 9XXX XXXX etc.Now is there...

Hello,I want to add the page extension in a hunt group, so that when there is an incoming call (pointing to the hunt group) pager system will also sound the incoming bell ringing. Is this possible ? Or if not is there any altrernate solution ?I don't...

Hello Folks,I upgraded to latest 2.0.13 which fixed many bugs. Now I am facing these two problems1. When a call is placed, the other party hears the voice after about 1 second of delay.2. When a prompt is recorded then UC reboots itself, why ?? Can'...