Hello, We recently acquired some WS-C2960S-48FPS-L switches. Almost every one of the switches shows this message on the console when connected via console cable. Is this benign?Switching, Catalyst 2000switch#mifs ifs_read 0 bytes
recently tried to update the firmware on a Catalyst 9200L-48P-4G using the Webui.I had selected "Desktop (HTTPS)" and downloaded the file "cat9k_lite_iosxe.16.09.04.SPA.bin" to the switch.Then when the Status moved to "Install Image/Package" there w...
We have an issue that a VM within VirtualBox on a MacBook is failing to get an IP address via DHCP served by a Cisco 2911 router when connected to a WLAN being serviced by 2 1832 APs running Mobility Express 8.10.105.0. Our physical lab setup:2x WAPs...
We have two 4351 ISRs that were running Everest 16.6.5 IOS that a security scan showed had this vulnerability even without the REST API being installed and activated. We upgraded to the referenced fixed IOS 16.6.6 however our scans still show this v...
I'm trying to configure a 2960 switch to use public key authentication rather than a username and password.I create the private key and export the public and add it to the switch config using. (config)#username user1(config)#aaa authentication login ...
I possibly had this same issue, for me the WEBUI software update method didn't apply the "boot system" commands to point to the new iOS. I had to navigate the html configuration directories in the browser to apply the boot system command for the corr...
"show ip ssh" shows the modulus of the local key in output as below. SSH Enabled - version 2.0
Authentication methods:publickey,keyboard-interactive,password
Authentication Publickey Algorithms:x509v3-ssh-rsa,ssh-rsa
Hostkey Algorithms:x509v3-ssh-rsa...
We do have a TAC case open but have yet to make any headway. I figured opening a thread would be useful for extra input and I can update with a solution/cause later. We don't have any other virtualization solutions, we moved away from fusion per our...
