Ignore the name, I am working on a 3 switch stack (using Stackwise 480) C9300 configC9300_Stack_Member_3(config)#$interface range tengigabitEthernet 1/0/40, tenGigabitEthernet 2/0/40C9300_Stack_Member_3(config-if-range)#switchport mode trunkC9300_Sta...

I am trying to upgrade a C9300-48-UXM-E from IOS XE 16.12.03a to IOS XE 17.03.03. I have followed all of the prerequisites and when I issue the following command:request platform software package install switch all file flash:cat9k_iosxe.17.03.03.SPA...

Hi, I am trying to setup a LACP group to connect an Aruba AP575 outdoor access point.   On the AP575 the primary ethernet port is capable of 2.5 Gbps and the secondary ethernet port is capable of 1Gbps.   The AP575 supports an LACP to give net effect...

Can I mix these two switches in a stack?   I am only using the Network Essentials features.   Since they are used I will not be able to get Cisco support, so before I create a stack with my existing C9300-24UX-E by adding a C9300-24UX-A, I wanted to ...

I currently only need network essentials   I am using IOS Fuji 16.9.3 on C9300 switches in my home. ThxBryan