About Jades

Jades · 06-20-2023

Hello there, I have a router 4321 running iWAN and PfRv3 with two internet links of 30MB/s. The question is... is there a way to balance the traffic when one of link hit 100% utilization? (the egress traffic change to another link less used) Thank yo...

Jades · 06-21-2023

"You're asking for the second link to only handle traffic in excess of the first link when it hits 100%?" I meant when any link hit 100% the traffic change to another link less used. I would say that the trigger would be the when hit 100% in any one....

Jades · 04-04-2023

Hello! This action worked for me when using authentication with PSK (WPA2 + AES). Devices not authenticating when this option "Flexconnect Local Auth" is disable. When enabled its worked immediately. WLC 5508 - 8.5.171.0 AP 1800 in FlexConnect Device...

Jades · 06-07-2022

Hi, I had this same issue on Prime 3.10 and WLC 5520 (8.10.171.0) during this days and the solution was the same. Thank you Jades!

Jades · 07-13-2020

I saw that AP dont received return from WLC, try to static config and after that put here the output "show capwap ip config". capwap ap ip address x.x.x.x x.x.x.xcapwap ap ip default-gateway x.x.x.xcapwap ap controller ip address x.x.x.xshow capwap ...

Jades · 07-12-2020

Hi buddy, Check the WLC9800 "Troubleshooting > Radioactive Tracing" the see AP join issues and also check the discover and join process via AP console.https://www.cisco.com/c/en/us/support/docs/wireless/catalyst-9800-series-wireless-controllers/21394...

Member Since	‎04-15-2019 12:58 PM
Date Last Visited	‎04-26-2023 12:02 AM
Posts	6
Total Helpful Votes Received	1

User Statistics

User Activity

iWAN and PfRv3 - Load balancing using two links

Re: iWAN and PfRv3 - Load balancing using two links

Re: Devices unable to connect to wifi network

Re: Prime 3.1 WLC Configuration Archive Failing

Re: More than one AP is not joint WLC 9800

Re: More than one AP is not joint WLC 9800