Hi, I am trying to configure RV340W with a Cisco 3560X switch. I have couple of VLANs on the switch that I need to trunk it to the port 1 if the RV340. I could find a place where I can enable trunking. Any ideas how do I do this. ThanksRohan
I tried tagging all the VLAN's (100,110,120) under the LAN1 port. LAN1 is connected to a 3560 switch port which is configured as trunk. But the port on the switch side shows the trunking status as "not-trunking"It should be straight forward config if...